Properties
| Manufacturer | Blastersmiths UK Ltd |
| Made from | 3D Printed PLA |
Rapidstrike Stock Block Kit
One of our most popular requested products for the Rapidstrike, this kit contains the usual rear plate and stock block which allows you to swap the collapsible stock on your Rapidstrike for one that will fit any Nerf standard stock mount. Want a Raider, Retaliator or one of the many Modulus stocks on the back of your fully automatic foam blaster? Well, now you can!
Lead times: This product is produced in house to order and as such takes a little time to make. Our fantastic 3D printing robots (because lets be honest, that's what they are!) are fast but during busy times things can stack up and it can take a little while to process. Full details can be found here.
Kit contains:
> 3D printed rear plate and stock block
> 4x M3x20 bolts and M3 locking nuts
Fitting information:
This video from BlasterTECH demonstrates the correct location to cut the rear section of the Rapidstrike to secure this plate in-situ. Prior to securing the rear plate, it is recommended you expand the pilot holes using a 3mm drill bit. The stock block can be drilled out using the same 3mm bit. A 6mm bit can be used to ensure there's enough room for the bolt caps which will be recessed into the block. Once you've secured the rear plate to the interior of the RS as shown in the video, you can bolt your stock block to your Rapidstrike.
Item is not a toy, unsuitable for use by persons under the age of 16
Lead times: This product is produced in house to order and as such takes a little time to make. Our fantastic 3D printing robots (because lets be honest, that's what they are!) are fast but during busy times things can stack up and it can take a little while to process. Full details can be found here.
Kit contains:
> 3D printed rear plate and stock block
> 4x M3x20 bolts and M3 locking nuts
Fitting information:
This video from BlasterTECH demonstrates the correct location to cut the rear section of the Rapidstrike to secure this plate in-situ. Prior to securing the rear plate, it is recommended you expand the pilot holes using a 3mm drill bit. The stock block can be drilled out using the same 3mm bit. A 6mm bit can be used to ensure there's enough room for the bolt caps which will be recessed into the block. Once you've secured the rear plate to the interior of the RS as shown in the video, you can bolt your stock block to your Rapidstrike.
Item is not a toy, unsuitable for use by persons under the age of 16